INTRODUCTION
The S6B0794 is a 160-outputs segment/common driver LSI for graphic dot-matrix liquid crystal display systems. It is fabricated by low power CMOS high voltage process technology. This device consists of 160-bits bi-directional shift register, 160-bits data latch and 160-bits driver. In case of segment mode, the data input is selected 4bit parallel input mode and 8bit parallel input mode by a mode (MD) pin. In case of common mode, data input/output pins are bi-directional, four data shift directions are pin-selectable.

FEATURES
Both Segment Mode and Common Mode
- Supply voltage for LC driver: +15.0 to +32.0V
- Number of LC driver outputs: 160
- Low output impedance
- Low power consumption
- Supply voltage for the logic system: +2.4V to +5.5V
- CMOS silicon gate process (P-type Silicon Substrate)
- Package: 190-pin TCP (Tape Carrier Package) & Gold bumped chip

Segment Mode
- Shift clock frequency: 14MHz (Max) (Vdd=+5V±10%)
                                      8MHz (Max) (Vdd=+2.4V to +4.5V)
- Adopts a data bus system
- 4-bit / 8-bit parallel input modes are selectable with a mode (MD) pin
- Automatic transfer function of an enable signal
- Automatic counting function which, in the chip select, causes the internal clock to be stopped by automatically counting 160 of input data
- Line latch circuit reset function when DISPOFFB active

Common Mode
- Shift clock frequency: 4.0MHz (Max) (vdd=+2.4V to +5.5V)
- Built-in 160 bits bi-directional shift register (divisible into 80-bits x2)
- Available in a single mode (160-bits shift register) or in a dual mode(80-bits shift register x2)
- Shift register circuit reset function when DISPOFFB active